™Request a fleet sample ↗

Fleet & heavy equipment / GreaseCheck

Fleet & Heavy
Equipment
Degreaser.

Cuts grease. Not your equipment.

GreaseCheck is a water-based degreaser concentrate supplied by LKA Industrial Solutions Inc. for truck fleets, service vehicles and heavy equipment. Its neutral pH working solutions remove oil, grease, soot and road film from vehicle surfaces. Choose the dilution for the soil and verify material compatibility before cleaning.

Illustration of a white semi truck being washed, showing its aluminium fuel tank and chassis.
Fleet care / Wash bay
Working solution pH7.0–7.5
01 / CHEMISTRYNeutral pH7.0–7.5 at working dilution
02 / FLASH POINTNoneAqueous solution
03 / TRANSPORTDOT not regulatedSee applicable SDS
04 / MIXING4, 7 or 11 gallonsFrom 1 US gal of concentrate

Where it fits

From the engine bay
to the last wheel.

Match the mix to the job. Start with a small area and check the finish before treating the whole vehicle.

01

Engines & chassis

Oil, grease and hydraulic residue on engine bays, transmissions, fifth wheels and undercarriages.

Industrial · 1:3 ↗
02

Trucks & equipment

Road film and working grime on trucks, service vehicles, wheels and construction machinery.

Heavy Duty · 1:6 ↗
03

Routine fleet care

Light soils on washable cab surfaces, glass and vehicle interiors during scheduled cleaning.

Multipurpose · 1:10 ↗
Why neutral pH matters

Aluminium, anodised trim and clear coats can be vulnerable to aggressive alkalinity. GreaseCheck avoids that alkaline attack mechanism. Finish condition, contact time and material compatibility still matter.

Dilution & yield

Mix for the soil.
Measure what you use.

All ratios are concentrate : water.
Add water first, then concentrate.

US gal
1.43US gal concentrate
+
8.57US gal water
7 galworking solution from
1 US gal concentrate

Mixing calculation assumes additive volumes. Follow the TDS for the selected dilution.

Application guide

A repeatable wash-bay routine.

Read Heavy Duty TDS ↗
01 / PREPARE

Check & mix

Check the surface, isolate sensitive electrical components and test an inconspicuous area. Select and measure the dilution.

02 / APPLY

Give it contact time

Apply the working solution. Heavy Duty: 1–3 minutes; Industrial: 2–5 minutes. Agitate where needed. Do not let it dry.

03 / RINSE

Rinse & inspect

Rinse the released soil away and inspect the finish. Capture wash water according to your site procedures.

Using a pressure washer or foam cannon

Calibrate the equipment to deliver the intended concentration at the surface. Injector ratios are not the same as the final dilution. The concentrate has moderate foam; check the TDS and equipment requirements before using it in automated wash systems.

Operator protection

Use safety glasses. Gloves are recommended for prolonged or repeated contact. Provide ventilation when spraying and avoid fine mist. Follow the applicable SDS and your site’s PPE requirements.

Technical documents

Check the data.
Choose the right sheet.

SDS and TDS for the concentrate and all three working solutions. PDFs hosted on greasecheck.com.

Working solution ratings do not replace the handling requirements for concentrate. Consult the sheet for the product you are using.

Fleet trial

Try it on the
vehicles you maintain.

Describe your fleet, the soil and your wash process. Use the trial to check the finish and compare time, water and chemical use.

01 Choose a representative vehicle.

02 Clean comparable areas to the same standard.

03 Record the result and total cost.

Complete the details below to prepare an email to our team. Send the message from your email app to submit your request.

Opens your email app with a draft. Your request is sent only when you press Send there. Prefer webmail? Copy the request below and send it to sales@greasecheck.com.

Copy request for webmail